Hi guys I’m Lory Bart, today let’s see how you can mount an updated modification for the Bosch Performance CX engine we already made a video With the editing of the change, however, this here has evolved and then I’ll show you updating how to connect and how to attract. First work to do and remove the battery Now we have to remove the crank to mount the modification, after which the plastic casing will be broken. To remove the crank arm you need this type of extractor with a wide cap Because otherwise it enters the hole so it takes off Et voilà dismounted crank Now we start to remove the whole part of the carter The change in question is this here with four plugs that from 150 euros we have to disconnect these two pins, we have to disconnect them with a screwdriver So, let’s break up One and two You can not go wrong because they are identical then practically The two pins they go in this verse here like this Those equal to each other male and female and the bigger one is the same Here it is done, the wires of the engine connected with the modification Now, the threads of the modification we go to the engine Ok for safety we fix the plugs with a bit of hot glue like that So that with the vibrations, they can not be detached Ok once the cables are fixed so they do not give interference nowhere let’s go to put the lid Now we fix all the screws on the lid and remount its cranks We tighten tightly Now let’s reassemble his battery We light Holding down the talk button the one below, it should appear 9.9 in fact So the change is active if you want to disable the monification press again talk and it comes out 2.5 in this way the modification is deactivated Now, we do not have to go and try it, I’m curious! Let’s see if it exceeds 25kmh I hope I have also been helpful with this video tutorial I recommend subscribe to my channel you like and see you in the next video. Hello guys.